A frayed or snapped lift cable throws the whole door off balance, and a door hanging crooked on one cable is a genuine safety hazard. We replace cables and inspect the drums they wind onto.
When one lift cable fails, the other has seen the same wear cycle. We replace both to prevent a repeat call.
Frayed cables often trace back to worn or damaged drum grooves, so we inspect the drums every time, not just the cable.
Our technicians are trained to safely release and reset tension when cables are involved, not just the springs.
We carry the common cable lengths and gauges for most residential door sizes.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
A snapped cable leaves the door hanging unevenly on the remaining side, an unsafe condition we treat as priority.
Fraying cable strands are a warning sign of imminent failure. We replace before it snaps and drops the door unexpectedly.
A cable that's jumped its drum groove can jam the door mid-cycle. We reset it correctly and check for the underlying cause.
Worn or cracked cable drums get replaced alongside the cable itself, since a damaged drum will fray the next cable too.
A door hanging crooked usually means one cable or spring has failed while the other holds. We correct both the immediate hazard and the root cause.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Cable stock on the truck means most calls avoid a second trip for parts.
Diagnosis includes the drums, not just the visible cable, before any price is confirmed.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Same-day fix on a Saturday, cable stock right there on the truck.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
Both cables typically get replaced together to avoid a near-term repeat call.
Yes, a door hanging on a single cable or spring can drop unexpectedly and should not be operated until repaired.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
Most cable replacements are completed same-day, typically within one to two hours once the technician arrives.
Same-day dispatch, upfront pricing, and a written warranty on every visit.
☎ Call +1-831-293-1591From one side of Kellogg to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Kellogg, ID